Pedalboard utility pedals

Mixer

Controls the level relationship between Bus A and Bus B signals. It can be inserted anywhere in the signal chain but is typically used at the end of the chain, shown at the extreme right of the Pedal area. See Use the Pedalboard Router for more information.

• Mix fader: Set the level or level balance, depending on the A/Mix/B switch position.

• A/Mix/B switch: Solo the “A” signal, mix the “A” and “B” signals, or solo the “B” signal.

• Pan knobs: Set the pan position for each bus.

Splitter

A utility that can be inserted anywhere in the signal chain. Splitter has two modes, set with the Freq and Split switch positions. See Use the Pedalboard Router for more information.

• Frequency knob: Set the frequency used to split signals when Freq mode is active.

• Freq switch: Works as a frequency-dependent signal splitter that divides the incoming signal. Signals above the frequency set with the Frequency knob are sent to Bus B. Signals below this frequency are sent to Bus A.

• Split switch: The incoming signal is routed equally to both buses. The Frequency knob has no impact in this mode.