Pedalboard utility pedals

This table describes the parameters of the Mixer and Splitter pedals.

Stompbox	Description
Mixer	Controls the level relationship between Bus A and Bus B signals. It can be inserted anywhere in the signal chain but is typically used at the end of the chain, shown at the extreme right of the Pedal area. See Use Pedalboard’s Router for more information. The A/Mix/B switch solos the “A” signal, mixes the “A” and “B” signals, or solos the “B” signal. The level setting of the Mix fader is relevant for all A/Mix/B switch positions. In stereo instances, the Mixer utility also provides discrete Pan controls for each bus.
Splitter	A utility that can be inserted anywhere in the signal chain. Splitter has two modes: Freq: Works as a frequency-dependent signal splitter that divides the incoming signal. Signals above the frequency set with the Frequency knob are sent to Bus B. Signals below this frequency are sent to Bus A. Split: The incoming signal is routed equally to both buses. The Frequency knob has no impact in this mode. See Use Pedalboard’s Router for more information.

Stompbox

Description

Mixer

Controls the level relationship between Bus A and Bus B signals. It can be inserted anywhere in the signal chain but is typically used at the end of the chain, shown at the extreme right of the Pedal area. See Use Pedalboard’s Router for more information. The A/Mix/B switch solos the “A” signal, mixes the “A” and “B” signals, or solos the “B” signal. The level setting of the Mix fader is relevant for all A/Mix/B switch positions.

In stereo instances, the Mixer utility also provides discrete Pan controls for each bus.

Splitter

A utility that can be inserted anywhere in the signal chain. Splitter has two modes:

Freq: Works as a frequency-dependent signal splitter that divides the incoming signal. Signals above the frequency set with the Frequency knob are sent to Bus B. Signals below this frequency are sent to Bus A.

Split: The incoming signal is routed equally to both buses. The Frequency knob has no impact in this mode.

See Use Pedalboard’s Router for more information.