Stereo Delay

The Stereo Delay works much like the Tape Delay (see Tape Delay), but allows you to set the Delay, Feedback, and Mix parameters separately for the left and right channels. The Crossfeed knob for each stereo side determines the feedback intensity or the level at which each signal is routed to the opposite stereo side. You can freely use the Stereo Delay on mono channels when you want to create independent delays for the two stereo sides.

Figure. Stereo Delay window.

As the parameters for the left and right delays are identical, the descriptions below only cover the left channel—the right channel information is provided in brackets, if named differently. Parameters that are common to both channels are shown separately.

Channel Parameters
  • Left (Right) Delay field: Sets the current delay time in milliseconds (this parameter is dimmed when you synchronize the delay time to the project tempo).
  • Groove slider and field: Determines the proximity of every second delay repeat to the absolute grid position—in other words, how close every second delay repeat is.
  • Note buttons: Set the grid resolution for the delay time. These are shown as note durations (these are dimmed when the delay time is not synchronized with the project tempo).
  • Left (Right) Feedback knob and field: Set the amount of feedback for the left and right delay signals.
  • Crossfeed Left to Right (Crossfeed Right to Left) knob and field: Transfer the feedback signal of the left channel to the right channel, and vice versa.
  • Feedback Phase button: Use to invert the phase of the corresponding channel’s feedback signal.
  • Crossfeed Phase button: Use to invert the phase of the crossfed feedback signals.
Common Parameters
  • Beat Sync button: Synchronizes delay repeats to the project tempo, including tempo changes.
  • Output Mix (Left and Right) sliders and fields: Independently control the left and right channel signals.
  • Low Cut and High Cut sliders and fields: Frequencies below the Low Cut value and above the High Cut value are filtered out of the source signal.